2013年苏州春季一次重污染天气的过程分析

研究了2013年3月在江苏范围内的一次重污染天气过程，重点分析苏州在此次污染过程中大气污染的变化特征。污染过程中，苏州市颗粒物浓度上升较为明显， PM10的小时质量浓度最高达548μg／m3， PM2．5质量浓度也达到197μg／m3，污染持续时间为2 d，3月8—9日当地空气质量均达到中度污染水平。根据后向轨迹模型、颗粒物离子浓度的分析，此次污染是由外来浮尘及苏州本地污染物排放所造成的区域霾污染影响所致。根据监测结果与实际污染特征，针对性地提出了对策和措施。     

Eutrophication conditions and ecological status in typical bays of Lake Taihu in China

Sampling was conducted at three site groups, group E (in East Taihu Bay), G (in Gonghu Bay) and M (in Meiliang Bay) in Lake Taihu. TN and TP concentrations among site groups was in the increasing order of E < G < M. TP level at G sites is at the critical threshold for loss of submersed macrophytes. Mean values of DO and Transparence showed different trend, i.e., E > G > M. The mean phytoplankton fresh-weight biomass at M sites was 5.81 mg/l, higher than that at E sites (4.96 mg/l) and G sites (5.18 mg/l). Mean zooplankton fresh-weight biomass was in the decreasing order of M (6.4 mg/l) > G (4.9 mg/l) > E (2.7 mg/l). However, Rotifera density was in the sequence of E > G > M. Both zooplankton biomass and phytoplankton biomass increased with the rise of TN and TP concentrations. Relationships between zooplankton biomass and phytoplankton biomass showed that zooplankton played a limited role in the control of algae in eutrophic lakes. Nutrient availability is much more important than zooplankton grazing pressure in controlling phytoplankton growth in lakes. For most sites in Lake Taihu, reduction of nutrient loading, as well as macrophyte conservation, zappears to be especially important in maintaining high water quality and regulating lake biological structure, but for M sites, it’s urgent to control nutrient inputs rather than to restore macrophyte community.     

Sorbents for the removal of airborne heavy metals from incinerator effluent

The effectiveness of inorganic alumino-silicate sorbents (alumina and kaolinite) to adsorb airborne lead and cadmium from the effluent stream of a simulated waste incinerator was studied. A 20 kW (68,000 BTU/h) flow reactor was used to achieve the temperature and residence times typical of a waste incinerator. Solutions containing lead or cadmium were introduced yielding airborne metals concentrations between 15 and 150 ppm. Gas samples were drawn into a particle impactor that collected the airborne particles and condensed phase metal aerosols, separating them into ten size ranges from 0.2 μm to greater than 10 μm. Metals to sorbent mass ratios between 0.03 and 1.56 were investigated. Scavenging efficiency increased as the ratio of sorbent to injected metal mass was increased. The scavenging efficiencies were as high as 76% for lead scavenged by kaolinite to as low as 14% for cadmium scavenged by alumina.     

Effect of combined addition amount of nano zero-valent iron and biochar on methane production by anaerobic digestion of corn straw

Environment, Development and Sustainability - Anaerobic digestion (AD) is an attractive straw resource treatment technology as it can improve the utilization efficiency of straw resource. Raw straw...     

中国集成电路制造行业VOCs排放特征及控制对策

中国电子信息产业发展迅速,集成电路等电子器件产量不断增加.在集成电路制造的过程中,大量有机溶剂的使用导致VOCs的产生和排放,从而对大气环境造成影响.为掌握集成电路制造行业VOCs的排放特征,系统分析了其工艺流程和产排污环节,分析了行业废气收集和治理现状,通过对典型企业VOCs的排放监测,获得VOCs排放水平;采用排放因子法核算行业VOCs历史排放量,并基于行业排放特征及减排潜力分析,提出了相应的污染防治对策.结果表明：在集成电路制造中,VOCs排放环节主要集中在光刻、清洗、去胶等过程,1 m²集成电路产量约使用87 g有机溶剂,VOCs产生量较大;通过采取高效的VOCs治理技术,集成电路制造行业有组织排放水平较低,平均浓度为2.1 mg·m^-3,但厂界无组织排放浓度相对较高,平均浓度为0.78 mg·m^-3,接近国家标准的排放限值.根据排放量核算结果,2011—2016年中国集成电路制造行业VOCs排放量呈逐年上升的趋势,主要受产量增加而相应污染控制技术水平提升有限的影响,无组织排放量比重大,占排放总量的38.1%~45.1%.     

不同来源土样胶体对氯霉素吸附行为的影响

选取不同来源沉积物或土壤样品（沉积物A1和A2,天然土壤B1和B2,市售营养土B3）,采用切向超滤与多种纳米分析技术相结合的方法,分析了不同土样中胶体的理化特征及其对氯霉素（CAP）吸附行为的影响.荧光区域积分法结果显示,土样胶体的荧光组分以色氨酸类蛋白质、类富里酸和类腐殖酸为主,络氨酸类蛋白质和溶解性微生物代谢物质存在较少.吸附实验结果表明,B3胶体对CAP的吸附率最大（36.25%）,在胶体浓缩液和超滤液中的分配比例最高（1.91）,但其有机碳归一化结合系数最低（3.93）.与天然土壤相比,河湖沉积物胶体的吸附率较高,但其与CAP的结合能力却较低.冗余分析结果表明,胶体对CAP的吸附主要与其芳香度、有色溶解性有机质丰度、溶解性有机碳浓度及分子量有关;此外,胶体的腐殖化程度、芳环上羧基、羰基等官能团的比重及荧光物质中溶解性微生物代谢产物和类腐殖酸对CAP的吸附行为也具有较大影响.     

生物质炭强化FeOOH类芬顿催化性能及其机制

采用醇助水热法制备了新型生物质炭修饰的α-FeOOH类芬顿催化剂（BC-FeOOH）,并通过扫描电子显微镜（SEM）、透射电子显微镜（TEM）、X射线衍射（XRD）、傅里叶变换红外光谱（FTIR）对催化剂进行了表征,证明生物质炭（BC）成功引入到α-FeOOH中.以罗丹明B（RhB）为目标污染物,考察了BC修饰量、催化剂及H₂O₂投加量对其催化效率的影响.结果表明,BC的引入可以极大地提高FeOOH的类芬顿催化性能.在pH中性、催化剂投加量0.6 g·L^-1、H₂O₂初始浓度10 mmol·L^-1的条件下,BC-FeOOH（22.2% BC）对RhB的降解率可达到90%,重复利用5次活性仍可保持在80%左右,且铁离子溶出浓度仅为0.08 mg·L^-1.进一步通过ESR在不同体系中的测试结果表明,BC的引入不仅可促进H₂O₂有效还原分解产生更多的羟基自由基（·OH）,而且增强了催化剂与污染物RhB的相互作用,促使污染物失电子氧化降解,从而提高了FeOOH的催化活性及催化稳定性.